Product ID:INDUSTRIAL HEAT RESISTANT, HR-057/059
MSDS Date:01/01/1987
FSC:8010
NIIN:00F004207
MSDS Number: BBPSN

HANLEY PAINT MFG/EL PASO, TX 79901

Emergency Phone: (915) 533-7481

Cage: 25450

HANLEY PAINT MFG/EL PASO, TX 79901

Cage: 25450

NAPHTHA (PETROLEUM SPIRITS OR BENZIN)

CAS: 8030-30-6

RTECS: SE7555000

Fraction By Weight: 22%

OSHA PEL 100 PPM

XYLENES (O-,M-,P- ISOMERS) (SARA III)

CAS: 1330-20-7

RTECS: ZE2100000

Fraction By Weight: 40%

OSHA PEL 100 PPM/150 STEL

ACGIH TLV: 100 PPM/150STEL;9192

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS

ALUMINUM (SARA III)

CAS: 7429-90-5

RTECS: BD0330000

Fraction By Weight: 30%

OSHA PEL 15MG/M3 DUST/5 FUME

ACGIH TLV: 10MG/M3 DUST; 9192

Effects of Overexposure:EYES: CAUSE IRRIT/REDNESS/TEARING/BLURRED
VISION. SKIN: CAUSE MODERATE IRRIT/DERMATITIS/DEFATTING.

First Aid:EYES: FLUSH WITH WATER. INHALATION: REMOVE TO FRESH AIR.
INGESTION: DON'T INDUCE VOMITING. GET MEDICAL ATTENTION. SKIN:
THOROUGHLY WASH EXPOSED AREA WITH SOAP/WATER. REMOVE CONTAMINATED
CLOTHING. LAUN DER CONTAMINATED CLOTHING BEFORE REUSE.

Flash Point:80F
Lower Limits:1.0%
Extinguishing Media:FOAM, CO2, DRY CHEMICAL
Fire Fighting Procedures:SCBA WITH FULL FACEPIECE OPERATED IN A
POSITIVE PRESS MODE.
Unusual Fire/Explosion Hazard:VAPORS HEAVIER THAN AIR, MAY BE IGNITED
BY SOURCES AT DISTANT, LOCATIONS.

Spill Release Procedures:ELIMINATE ALL IGNITION SOURCES(FLAMES/SPARKS).
STOP SPILL AT SOURCE. DIKE AREA TO PRENT SPREADING. PUMP LIQUID TO
SALVAGE TANK. REMAINING LIQUID MAY BE ABSOED ON ABSORBENT MATERIAL
AND SHOVELED INTO C ONTAINERS.

Handling and Storage Precautions:SINCE EMPTIED CONTAINERS RETAIN
PRODUCT RESIDUES, ALL PRECAUTIONS IN THIS SAFETY DATA SHEET MU BE
FOLLOWED WITH EMPTY CONTAINERS.

Respiratory Protection:IF TLV IS EXCEED, AN APPROPRIATE AIR SUPPLIED
RESP SHOULD BE USED.
Ventilation:PROVIDE EXHAUST VENTILATION TO KEEP BELOW TLV.
Protective Gloves:NITRILE RUBBER
Eye Protection:GOGGLES
Other Protective Equipment:WEAR IMPERVIOUS CLOTHING TO PREVENT SKIN
CONTACT.
Supplemental Safety and Health
MSDS DATE: 15 NOV 1985. WT/GAL: 9.3 LB.

Boiling Pt:B.P. Text:280-410F
Vapor Density:>AIR
Evaporation Rate & Reference:SLOWER THAN ETHER
Percent Volatiles by Volume:75%

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:KEEP AWAY FROM HEAT, OPEN FLAME, IGNITION
SOURCES.
Hazardous Decomposition Products:CO, CO2, HYDROCARBONS

Waste Disposal Methods:ABSORBENT MATERIAL CONTAINS FINELY DIVIDED
ALUMINUM. CONSULT WASTE DISPOSAL OFFICIALS AS TO PROPER METHODS OF
DISPOSAL.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.